Editing 7 Segment Display (section)

== Getting started ==

Each of the segments on the 7 Segment Display can be switched on and off individually using the SWITCH ON and SWITCH OFF commands.
Usually the Digital Outputs are identified using the numbers printed onto the top of the Smart Box, for example SWITCH ON 1 will switch on Digital Output 1.
Each segment of the 7 segment display is labelled on the circuit board using the standard notation for such displays.
The segments are labelled a to g and the decimal point is marked dp.
The Smart Move software allows the outputs to be renamed to match the display and subsequently makes for easier programming of the unit.

Type the following eight lines in as direct commands to label the outputs as required.
Note that there is not a space between the word output and the number.

 LABEL OUTPUT0 A
 LABEL OUTPUT1 B
 LABEL OUTPUT2 C
 LABEL OUTPUT3 D
 LABEL OUTPUT4 E
 LABEL OUTPUTS F
 LABEL OUTPUT6 G
 LABEL OUTPUT7 DP

Now try switching on one of the segments by typing SWITCH ON C