Editing Digital Sensors (section)

== An example project ==

The following example uses three digital sensors and a buzzer to create a simple security system.

Sensors 0 and 1 are magnetic contact switches which will open as a door or window is opened.
A push switch is connected to sensor 2 which is used to switch off the system.
The Digital sensors can be ‘Labelled’ or given an alternative name using the LABEL command in Smart Move.
This makes the sensors easier to identify.
In the same way some of the Smart Move keywords can be changed.
In this example the keyword OFF is changed to OPEN.
The [[LABEL|reference section]] gives more details.

[[File:Monitor-Alarm-Sensor-Labels.png|frame|right|Macintosh monitor window showing labels]]

Type in the following as direct commands

 LABEL OFF open
 LABEL SENSOR0 door
 LABEL SENSOR1 window
 LABEL SENSOR2 turnoff
 LABEL OUTPUT0 buzzer

Type in all the procedures as shown then run the ''Alarm'' procedure.

=== Procedure: Alarm ===

 REPEAT
 IF DOOR IS OPEN THEN Soundalarm
 IF WINDOW IS OPEN THEN Soundalarm
 UNTIL TURNOFF IS ON
 Stopalarm

=== Procedure: Soundalarm ===

 SWITCH ON buzzer PULSE 50,50

=== Procedure: Stopalarm ===

 SWITCH OFF buzzer

[[Category:Sensors]]