Editing Setting up (section)

== Setting up procedure ==

# Make sure that your computer is switched off.
# Connect the serial cable between your computer and Smart Box.
# Plug the power cord supplied with Smart Box into the power inlet socket on the rear panel.<br /><hr />'''Warning''' ''This equipment is intended to be electrically grounded. The power cord supplied is fitted with a three pin plug and should only be used with the correct three pin - grounding type - outlet.''<hr />
# Switch on your computer in the normal way.
# Switch on Smart box. The switch is on the moulded power inlet socket. You will see the red ‘on’ LED light on the top of the box. All the Green LEDs will also flash. Smart Box is now ready for use.

Note, if Smart Box is powered up first it may receive spurious signals from the serial port as the host micro starts up, in this case press the reset button on the rear of Smart Box to make sure that it is ready to receive commands from your software.

[[Category:Smart Box]]